Before you start to apply your new Wall Glamour wall stickers we suggest you take a minute to prepare yourself and read these instructions through fully. Although Wall Glamour is easy to fit, it does require a little patience for larger items. It’s a good idea to plan where you are going to put your new purchase in advance of peeling the silicon paper off. Care needs to be taken when fitting Wall Glamour, as it is not a reusable item. It can easily be removed but it will more than likely be damaged.

How to fit small wall stickers in four steps.

Step One Position the stickers with masking tape onto surface. Some items will be supplied pre-cut but it may be of use to trim around the graphic to aid applying.		Step Two Lift graphic and carefully peel the backing paper to half way, making sure all the graphic is on the clear transfer film. If the vinyl is stuck to the paper smooth the paper back onto the transfer film until it sticks then re-try.		Step Three Move the scraper over the film at 45 degrees as you apply. Apply in a firm smooth motion so you don’t get any air bubbles. Remember vinyl is very sticky so keep the rest away from wall whilst you apply.		Step Four Wait about 30 mins then peel back the edge of transfer film & remove by pulling slowly and carefully away at 180 degrees to vinyl. Make sure non of the vinyl pulls up with the transfer film. Take care when removing from a painted wall.

How to fit large wall stickers in eight steps.

Step One Position vinyl then masking tape onto surface. Some items will be supplied pre-cut but it may be of use to trim around the graphic to aid applying.		Step Two Tape wall sticker across the centre, making sure there is enough tape to hold onto the wall.		Step Three Untape top edge of sticker, carefully peel the backing paper to half way, making sure all the graphic is on the clear transfer film. If the vinyl is stuck to the paper smooth the paper back onto the transfer film until it sticks.		Step Four Trim the backing paper off at halfway so that the top part of the sticker can be applied to the wall. Remember vinyl is very sticky so keep the adhesive away from the wall or clothing.

Step Five Move the scraper upwards (from the halfway point) over the film at 45 degrees as you apply. Apply in a firm smooth motion so you don’t get any air bubbles.		Step Six Once you have applied the top half, carefully peel the backing paper from the bottom half, making sure all the graphic is on the clear transfer film.		Step Seven Move the scraper downwards (from the halfway point) over the film at 45 degrees as you apply. Apply in a firm smooth motion so you don’t get any air bubbles.		Step Eight Wait about 30 mins then peel back the edge of transfer film & remove by pulling slowly and carefully away at 180 degrees to vinyl. Make sure non of the vinyl pulls up with the transfer film. Take care when removing from a painted wall.

Fitting Video - More on our YouTube Channel

The instructions above are available as a PDF via Google Docs
by clicking here for the small instructions 
or clicking here for the large fitting instructions.

We have industry experience of applying vinyl, which we have tried to pass on in a simple, easy to use way. However we cannot take any responsibility for errors you make during the fitting of your Wall Glamour. We also cannot be held responsible for any damage to paint work when you are removing Wall Glamour. This is a DIY home decoration product and is supplied on the premise that you may have to touch up areas of paintwork after removal.